Home › Guides › Worth it this winter?

Is a standby generator worth it this winter?

Updated Nov 18, 2026

Every fall, a lot of homeowners ask the same question: is this the winter to finally get a standby generator? There's no single right answer. It depends on how often your power goes out, what you need to keep running, and what an install costs where you live. This guide pulls together what the official winter outlooks for 2026-27 actually say, what published sources and homeowners say a standby generator costs, and a few plain questions to help you decide.

We've quoted each outlook carefully and linked it, so you can read the original. None of them predicts outages at your address. They're about the big regional grids and the season's weather odds.

What the grid operators say about this winter

The large grid operators publish a winter outlook every year. Two of the biggest released theirs in the last few weeks.

PJM (13 states and Washington, D.C.)

PJM runs the grid for 13 states and the District of Columbia, stretching from New Jersey and Pennsylvania to Illinois, Kentucky, Tennessee, Virginia and North Carolina. Its outlook says PJM "expects to have sufficient resources to reliably meet electricity demand this winter under expected conditions, though reserve margins continue to tighten as demand outpaces new power supplies" (PJM Interconnection, Nov 5, 2026).

PJM expects 182,426 MW of operational capacity against a forecasted peak demand of about 147,500 MW, a peak it says would set a new winter record if reached (PJM Interconnection, Nov 5, 2026). It singles out areas where transmission limits make it harder to bring power in from elsewhere, "especially the BGE, Pepco and Dominion zones in Maryland, Virginia and the District of Columbia" (PJM Interconnection, Nov 5, 2026). And it notes that "significantly higher levels of generator outages, such as those that occurred during Winter Storm Elliott (~46,000 MW), could leave the system vulnerable to power outages" (PJM Interconnection, Nov 5, 2026).

In plain terms: under normal winter conditions, PJM expects enough power. The cushion is getting thinner, and the outlook describes an extreme cold snap with many power plants down as the scenario that would strain the system.

MISO (15 states, the central U.S.)

MISO runs the grid across 15 U.S. states and the Canadian province of Manitoba. Its winter readiness assessment reports about 134.7 GW of winter capacity offers against a projected winter peak of about 113.4 GW (MISO, Oct 28, 2026). MISO says the region enters winter with sufficient capacity, and adds: "Tighter reserve margins, steep evening ramp periods and the potential for large winter storms can create challenging operating conditions" (MISO, Oct 28, 2026).

What that means for a homeowner

Both grid operators expect enough power supply under expected conditions. Keep in mind what these outlooks cover: whether there's enough power across a whole region. They don't forecast local outages, such as storm damage to the lines on your street. If your neighborhood tends to lose power in storms, your own history is a better guide than any regional outlook.

What NERC says

NERC, the North American Electric Reliability Corporation, published its 2026-2027 Winter Reliability Assessment on November 18, 2026. Our separate guide, Winter power outage risk 2026-27: what NERC says, summarizes what it says about normal and extreme winter conditions, demand growth and natural gas fuel.

What NOAA expects for weather

NOAA's winter outlook covers December 2026 through February 2027. It calls for "warmer-than-average temperatures expected across the northern U.S.; wetter-than-average conditions likely across the southern U.S., from California to Florida, and along the Eastern Seaboard" (NOAA, Oct 15, 2026).

The National Weather Service director explained that a very strong El Nino "tilts the odds toward stormier weather across the South" (NOAA, Oct 15, 2026). NOAA is also clear about the limits of a seasonal outlook: it "does not project seasonal snowfall accumulations as snow forecasts are generally not predictable more than a week in advance" (NOAA, Oct 15, 2026). PJM's outlook likewise notes that the National Weather Service predicts a slightly warmer winter for much of the country, including all of PJM's area (PJM Interconnection, Nov 5, 2026).

So a warmer-than-average season in the North is the most likely outcome. That says nothing for sure about any single storm or cold snap.

What EIA expects for energy bills

The U.S. Energy Information Administration expects a mixed picture for home heating costs this winter. It says energy spending "will decrease on average by 9% in homes heating with natural gas and by 3% in those heating with propane," while homes heating with electricity will see "a 4% increase in electricity bills on average" (U.S. Energy Information Administration, Oct 7, 2026).

Those figures are about heating bills, not generator fuel, but they're a useful snapshot of natural gas and propane prices this season. Home standby generators typically run on one of those two fuels. Our natural gas vs. propane guide covers how fuel choice affects the install.

What a standby generator costs installed

Here's what published cost sources say. HomeGuide puts a typical whole house generator at $6,000 – $11,000 (HomeGuide, accessed Nov 2026) installed, and $9,500 – $24,000 (HomeGuide, accessed Nov 2026) for long distances or units over 20 kW. This Old House gives $7,178 – $13,959 (This Old House, accessed Nov 2026) including the unit, installation and transfer switch. Angi's figure for what most homeowners pay on its projects is $1,509 – $8,799 (Angi, accessed Nov 2026).

Those ranges are national. The biggest swings usually come from size, the gas line run and electrical work. HomeGuide lists unit-only prices of $4,000 – $6,000 (HomeGuide, accessed Nov 2026) for 17–20 kW and $4,500 – $12,000 (HomeGuide, accessed Nov 2026) for 22–25 kW, and automatic transfer switch installation at $600 – $2,500 (HomeGuide, accessed Nov 2026).

From homeowners on this site: We're still collecting reports for a national median (0 of 3 needed).

To see figures for your own area and size, look up local install costs. If you already have a quote, check whether it's fair.

How to decide if it's worth it for you

A standby generator is a big purchase, so it helps to be honest about what you need. A few questions to ask yourself:

  • How often does your power go out, and for how long? Your own history matters more than any regional outlook. A few short outages a year is a very different situation from multi-day outages after ice storms.
  • What do you need to keep running? A sump pump, well pump, furnace blower and refrigerator need far less capacity than a whole house with central air and an electric range. Our generator size calculator adds up the appliances you pick and suggests a size in kW.
  • What would an outage cost you? Think about frozen pipes, a flooded basement, spoiled food, working from home, or someone in the house who relies on powered medical equipment.
  • What's the installed price where you live? Size drives the unit price, and site conditions drive the rest. Get an itemized quote so you can compare it.
  • Is a smaller setup enough? Backing up only essential circuits can mean a smaller generator than whole-home coverage. Our transfer switch guide explains the difference.

If the answers point toward yes, start with the size. Then compare installed prices for that size, and get more than one quote from licensed installers.

A note on safety

A standby generator connects to your home's wiring and fuel supply. This site doesn't give installation, code or safety advice. Use a licensed installer, and follow your local codes and permit requirements.

Already installed one?

The prices on this site come from homeowners. If you've had a standby generator installed, report what you paid. It takes about two minutes, we never publish your name, email or address, and it helps the next person in your area know what a fair price looks like.

Sources

Related guides

Check my quote Look up local costs